Safer Work Environment!

DTI Collision Avoidance Warning System is designed to increase Safety

in the Work Place Alerting Potential Collisions with Vehicles hidden in blind spots.

•ADDITIONAL Layer of SAFETY!

                               •Economical Cost!

DTI CAS is added Safety Protection Communication tool that makes the hailed operator acknowledge           

the presence of a unseen vehicle or equipment entering a work area.

Unlike other CAS the DTI CAS requires the hailed operator to acknowledge the alerting vehicle, or the

equipment they are operating will stop until the hail is responded to... a Fail Safe protocol system.

FEATURES:

          • Universal RF... CAS comes with 9 different RF frequencies signals (340 kHz to 900 MHz) to   

             meet all worldwide regions.

           • Easily Installation... Nodes (units) install easily on unlimited number of existing or new

            equipment.  Minimum wiring required.

           • Secondary Fail Safe... In case of primary CAS failure, or uncertainty of correct

             operation of primer CAS, activation of DTI CAS offers secure secondary Collision Avoidance

             awareness for new equipment.

            • Economical... A very economical safety upgrade to a fleet’s existing equipment or safety system.

            • Blanket Coverage... Activating DTI CAS or hailing will send an alert signal to all DTI CAS

             units in range.

            • Expandable... As your fleet grows DTI CAS units can be installed on any new or used equipment

              with no adjustments to previous installed DTI CAS units.

            • Secure Acknowledgement Response... When DTI CAS alert hail signal is activated all

               equipment in range must acknowledge alert hail to avoid an alarm or equipment stoppage by DTI CAS.

            • Personal CAS... Integrating the personal hand held Guardian adds even more protection

              and safety control for supervisor and maintenance personnel giving them the ability to shut

              down equipment if a potential dangerous or unsafe situation arises in the work area.

Specifications:

Length ...................................................... 8"

Width ........................................................ 6"    

Height ....................................................... 2.75" (7.25” including antenna)

Weight ...................................................... 3.0 lbs (approx)

IP ................................................................. 4X

Operating Temperature Range ........ -25ºC to 85ºC

RF.................................................................. 900MHz (Operating Frequency)

Electrical Specifications:

Vin ............................................................... 12VDC

Nominal Current .................................... 300mA

Max switching voltage ........................ 277VAC (relay output)

Max switching current ........................ 20A

rating switch cycles .............................. 100 000